I was randomly sketching on CS5 (using brush) and I stumbled upon an effect that I was not able to replicate after. A relative newbie, no custom brush. using a wacom intuos that sometimes lost its settings and unresponsive.
If you look at the enclosed sketch, you can see that where the red arrows are pointing. Whenever I tried to draw a single stroke and turned a sharp corner, the ink seems to "bleed" to fill up the acute angle. The most obvious location is the nose on the left hand side, I draw the nose in one stroke, first the upper one, then when I turned the corner at the point of the nose, the ink "bleeds" as if trying to fill up the acute angle by capillary action. Similar effects were seen at the sharp chin, elbows, etc. wherever i turned a corner in one stroke. I thought this was a nice effect and I want to continue to do sketches in this way. However, after I closed CS5 and went back, I could not replicate such effect. I don't think I have change the brush at all. As you can see, on the right hand side are the 2nd trials, I lost the "bleeding" effect. I had no idea how I accidentally achieved such effect and I want to find out how! Could someone please identify what it is, what settings do I change to replicate this again? Any help would be highly appreciated!
If you look at the enclosed sketch, you can see that where the red arrows are pointing. Whenever I tried to draw a single stroke and turned a sharp corner, the ink seems to "bleed" to fill up the acute angle. The most obvious location is the nose on the left hand side, I draw the nose in one stroke, first the upper one, then when I turned the corner at the point of the nose, the ink "bleeds" as if trying to fill up the acute angle by capillary action. Similar effects were seen at the sharp chin, elbows, etc. wherever i turned a corner in one stroke. I thought this was a nice effect and I want to continue to do sketches in this way. However, after I closed CS5 and went back, I could not replicate such effect. I don't think I have change the brush at all. As you can see, on the right hand side are the 2nd trials, I lost the "bleeding" effect. I had no idea how I accidentally achieved such effect and I want to find out how! Could someone please identify what it is, what settings do I change to replicate this again? Any help would be highly appreciated!
Attachments
Last edited: