theone1979
New Member
- Messages
- 1
- Likes
- 0
Hello
then i try to record a action to insert my logo to a image i do this
i start with open a image this in portrait
use automate fit image to make sure that is no bigger then 800x800px
and then i place my logo in and under size i say 140px wide.
and i all look good but is i open a other image there may be in landscape and run the action the logo is not 140 wide.
i found out that is because transform dont record how many pixels you type, it converted in to % and there for the size get wrong..
in there any way get to be 140 % wide every time (getting it to record it in PX)
then i try to record a action to insert my logo to a image i do this
i start with open a image this in portrait
use automate fit image to make sure that is no bigger then 800x800px
and then i place my logo in and under size i say 140px wide.
and i all look good but is i open a other image there may be in landscape and run the action the logo is not 140 wide.
i found out that is because transform dont record how many pixels you type, it converted in to % and there for the size get wrong..
in there any way get to be 140 % wide every time (getting it to record it in PX)