Reply to thread

I've got a situation where my cursor will blink on and off when I am trying to use the clone stamp tool.

 When it happened this time I had selected the Elliptical Marquee tool and created a circle on an object.  I then chose the clone stamp tool and proceeded to clone inside the circle.  I was  just using the circle as a guide for the area I wanted to clone.   When I did  this I noticed that the clone tool cursor would blink on and off it will also keep on blinking as I move the cursor outside of the circle for a small distance and then if I keep on moving away from the circle it will eventually stop blinking.  [confused]

Is there some kind of an adjustment that I can make to prevent this from happening.

Thanks