Reply to thread

I think I get what you're asking. But unfortunately, I don't know of a plugin that does this automatically. But someone here may know of one......

If I were to do this, I would increase the image size in increments until I get to the size needed for print. Hold up the drawing (or a ruler) against the monitor to see if it matches.

Take note, the PS ruler when viewed in Actual Pixels isn't that accurate - 1 inch in normal 100% PS view is not actually one inch in real world measurement. So in the navigator, I key in 130% to compensate.  It might be different on your monitor so you have to adjust + - to suit. This will ensure the viewing accuracy so you can cross check the PS image to the drawing properly.

Printing is another thing - You may have to do a test print to see if the resized image is to the spec you need. If not, you increase or decrease..... either via print setting or on the PS work document.