Unsure if I have the correct section of the forum to post this question, hopefully it makes sense.
I just switched from cs3 to cs5. A few things seem to be working a bit different and I maybe am lost on something that may be basic.
I been using cs3 for years to do stuff for print and web use. This issue is choppy lines. Normally in the past I would do the following to trace an image to remove it. I would use the magic wand, or the polygon lasso tool and remove the unwanted, my edge lines were also nice and clean. Now with using cs5 no matter what i trace around, cut out or anything im getting a line that is a bit jagged/choppy. I dont have cs3 anymore so cant compare anything. Is there a settings area(besides using feather) that can be adjusted?
I havnt tried the new selection tools instead as just doing a basic thing like before and having this problem no matter what.
Hopefully this makes sense and imoverlooking something. Thanks for any help.
I just switched from cs3 to cs5. A few things seem to be working a bit different and I maybe am lost on something that may be basic.
I been using cs3 for years to do stuff for print and web use. This issue is choppy lines. Normally in the past I would do the following to trace an image to remove it. I would use the magic wand, or the polygon lasso tool and remove the unwanted, my edge lines were also nice and clean. Now with using cs5 no matter what i trace around, cut out or anything im getting a line that is a bit jagged/choppy. I dont have cs3 anymore so cant compare anything. Is there a settings area(besides using feather) that can be adjusted?
I havnt tried the new selection tools instead as just doing a basic thing like before and having this problem no matter what.
Hopefully this makes sense and imoverlooking something. Thanks for any help.
