Hello,
As I was doing "Unsharp" to my photos, I've noticed that after I click OK, the sharpness immediately goes down a bit.
The photos are of gemstone Jewelry closeups, for print, taken with Canon PowerShot A10, in High Resolution.
The numbers I use are quite high, since this type of jewelry has many small pieces of beads,chips - so I use Sharpness 180-245, Radius 5-7, Treshold 2.
My previous prints came out very nicely, and I haven't payed attention if the same thing was happening before.
Some came out with not enough contrast(foggy a little), that's why I'm redoing these ones.
Any idea why this happens?
Thanks!
As I was doing "Unsharp" to my photos, I've noticed that after I click OK, the sharpness immediately goes down a bit.
The photos are of gemstone Jewelry closeups, for print, taken with Canon PowerShot A10, in High Resolution.
The numbers I use are quite high, since this type of jewelry has many small pieces of beads,chips - so I use Sharpness 180-245, Radius 5-7, Treshold 2.
My previous prints came out very nicely, and I haven't payed attention if the same thing was happening before.
Some came out with not enough contrast(foggy a little), that's why I'm redoing these ones.
Any idea why this happens?
Thanks!