ALB68
Dear Departed Guru and PSG Staff Member
- Messages
- 3,020
- Likes
- 1,332
I was watching a video about Photoshop and the pro broached the subject of how to set your PS preferences, so that you get a true representation of your documents print size. Seems this was a topic a while back and I'm not sure it was ever answered. Here is an explanation and the fix.
Seems that Adobe sets the default for screen resolution in Preferences/ Units and Rulers to 72ppi. Today's monitors are usually more than that, so when you tell PS to show you Print Size, it's going to show you something less than what it actually is. To fix this is actually pretty simple. Here's how.
1. Create a new document 9" x 9" @ 300ppi, use white for the background color.
2. In your zoom mode activate Print Size
3. Grab a tape measure and carefully measure what your seeing on the screen. If it is not 9x9, then your setting is not set properly in Preferences/Units and Rulers.
4. More than likely your measurement is smaller by a good bit. At this point, create a correction factor by dividing 9 by the actual measurement.
5. Then, in the Preferences as previously described, if 72ppi, multiply by the factor you just created and enter it exactly (not rounded) to the decimal point.
Now, when you ask PS to show Print Size it will show you the actual, not something less.
Hope this of help to someone.
Seems that Adobe sets the default for screen resolution in Preferences/ Units and Rulers to 72ppi. Today's monitors are usually more than that, so when you tell PS to show you Print Size, it's going to show you something less than what it actually is. To fix this is actually pretty simple. Here's how.
1. Create a new document 9" x 9" @ 300ppi, use white for the background color.
2. In your zoom mode activate Print Size
3. Grab a tape measure and carefully measure what your seeing on the screen. If it is not 9x9, then your setting is not set properly in Preferences/Units and Rulers.
4. More than likely your measurement is smaller by a good bit. At this point, create a correction factor by dividing 9 by the actual measurement.
5. Then, in the Preferences as previously described, if 72ppi, multiply by the factor you just created and enter it exactly (not rounded) to the decimal point.
Now, when you ask PS to show Print Size it will show you the actual, not something less.
Hope this of help to someone.