Thanks for accepting me on your wonderful forum I've been looking around and there's a lof of knowledge here.
I am an electronics hobbyist and have played with photoshop here and there but this time I'd like to know the right way to draw this.
I need to print out an altered face following the original design. Then I can glue it on the original face.
I have to believe it would be easier to make a new scale rather than trying to mask and copy but even then how do apply the radius to it.
It just crossed my mind perhaps this is more of job for illustrator?
What do you guys think
Thanks in advance
Micheal from Michigan
Last edited: